R51/3 Splash Ring

Begonnen von Michael Steinmann, 21 März 2020, 11:08:16

« vorheriges - nächstes »

0 Mitglieder und 2 Gäste betrachten dieses Thema.

Michael Steinmann

Hello all,
I'm new here, thanks for letting me in.
Nr. 1 in this diagram is the oil splash disc:
If I got it right, the assembly order goes like this: rear main bearing, this splash ring with its protruding side towards engine/bearing, the oil seal and then the wave washer. I think that this splash ring will sit loose in there, as the oil retaining seal is only 7 mm thick, not to mention that the workshop manual claims to mount this seal in such a way that it will stand out 1 mm.
Is this correct? Should it be that way, loose inside?
Or am I wrong, and it will be a tight fit?
Or am I missing something?
Thanks a lot for any help,
Micha Steinmann




F.B.

Hi Micha,
that oil splash ring is fixed by the fly wheel of the clutch that will press it towards the inner ring of the bearing.
Best regards 
Frank

Rütz

Zitat von: Michael Steinmann am 21 März 2020, 11:08:16
this splash ring with its protruding side towards engine/bearing,
Vice versa. (outer protruding side towards flywheel)
Otherwise it will grind on the outer bearing ring.

Hauptmenü

Startseite Baureihe Vergleichsliste Specials Anleitungen & Bücher

Presse & Wissen

Historisches Liste der BMW Modelle Bauzeiten & Stückzahlen Prospekte & Plakate Presseberichte

Tipps & Service

Tipps Händler Dienstleister Märkte & Museen Verschleißteile & Werkzeuge

Foren & Literatur

Bildtafel-Suche Forum: Einzylinder Bildergalerie Servicedaten Handbücher

Allgemeine Infos

Kontakt Sitemap Glossar Impressum Bildtafelsuche